Guides For Other Useful Programs - Daewoo DWF-33CG Series Instruction Manual

GUIDES FOR OTHER USEFUL PROGRAMS

Partial Selection Among Wash, Rinse or Spin
Partial Process
1. Press the Power button first.
Only Wash 2. Press the Process button twice and press the Control button until desired washing time is selected.
3. Press the Process button once again and then press the Control button until rinsing time reads "0".
4. Press the Process button once again and then press the Control button until spinning time reads "0".
twice
Only Rinse 2. Press the Process button twice and press the Control button until washing time reads "0".
3. Press the Process button once again and press the Control button until desired washing time is
selected.
4. Press the Process button once again and then press the Control button until spinning time reads "0".
twice
Wash & Rinse 2. Press the Process button twice and press the Control button until desired washing time is selected.
3. Press the Process button once again and press the Control button until desired rinsing time is
selected.
4. Press the Process button once again and then press the Control button until spinning time reads "0".
twice
Wash & Spin 2. Press the Process button twice and press the Control button until desired washing time is selected.
3. Press the Process button once again and then press the Control button until rinsing rinsing time
reads "0".
4. Press the Process button once again and press the Control button until desired spinning time is
selected.
twice
5. Select desired water level and water temperature.
6. Press the Start/Pause button with closing Lid(Door).
select the
water level
* After this process, the Drain process will not occur. If desired, use Spin button (refer to below).
* Buzzer notifies the end of cycle. Power switch turns off automatically.
Process Procedure
select
once again
washing time
washing time
once again
reads "0"
select
once again
washing time
select
once again
washing time
select the
water temp.
Close lid
11
rinsing time
once again
reads "0"
select
once again
rinsing time
select
once again
rinsing time
rinsing time
once again
reads "0"
spinning time
reads "0"
spinning time
reads "0"
spinning time
reads "0"
select
spinning time