Inlet Hose Connection - Daewoo DWF-33CG Series Instruction Manual

INLET HOSE CONNECTION

• Water supply pressure must be between 4.5 and 145 PSI (30~1000 kPa).
• Do not crossthread when connecting inlet hose to the valve. If the water supply pressure is more
than 145 PSI, a pressure reducing device should be installed.
• Two Sealing washers are supplied with the water inlet hoses to prevent water leaks.
• Check for leakage of washing machine connections by turning the tap completely on.
• Periodically check the condition of the hose and
replace the hose if necessary.
• Make sure that there is no kink in the hose and that it is
not crushed.
• Be sure that the two water input ports are connected to
the correct water faucets. The connector for hot water
is colored red.
Repairs to the washing machine must only be carried out by qualified personnel. Repairs carried
out by inexperienced persons may cause injury or serious malfunctioning. Contact your local
service center.
Do not install your washing machine in a room where temperatures below freezing may occur.
Frozen hoses may burst under pressure. The reliability of the electronic control unit may be
impaired at temperatures below the freezing point
If the appliance is delivered in the winter months and temperatures are below freezing, store the
washing machine at room temperature for a few hours before putting it into operation.
NOTES
• When connecting the water inlet valve, please find the symbol for each.
for hot water inlet,
(Connect to the faucet)
for cold water inlet.
6
(Connect to the water
valve of the washer)