Operating The Unit; Operation - Elmo CRC-1 Instruction Manual

5. Operating the Unit

Operation

Select either the Computer, Document Camera or VIDEO input to determine the image and
audio to output from the unit.
Below is a simple description of how to operate the unit.
Complete all the peripheral device connections and unit settings, and
then connect the power cord to the outlet.
To turn on the projector power, press the
The projector power turns on, the green LED of the ON button flashes. When the LED of
the ON button stops flashing and stays on, the red LED of Computer turns on and the
RGB1 image and AUDIO1 audio are output.
To turn off the projector power, press the
The audio output and projector power turn off. The red LED of the OFF button flashes.
When the LED of the OFF button stops flashing, the OFF LED stays on.
After pressing the OFF button, leave some cooling time before using the
projector again.
Caution
Do not press the ON button while the projector is cooling.
To adjust the AUDIO volume, press
To mute, press the
When the mute is operating, the red LED on the button is lit.
To cancel the mute, press the button again.
The MIC volume does not change with Volume Up/Down.
Caution
Adjust the volume of a connected microphone with MIC Volume.
To mute, turn MIC Volume until it stops on the MIN side.
The AUDIO volume does not change with MIC Volume.
Caution
To blank the image, press the
When the image is blanked, the red LED is lit. To cancel, press the BLANK button again.
The LED turns off.
/
(MUTE) button.
(BLANK) button.
(ON) button.
(OFF) button.
(Volume Up/Down).
21