Appendix; Selecting A Projector To Use - Elmo CRC-1 Instruction Manual

8. Appendix

Selecting a projector to use

■ Recommended models (as of February 2010)
1. Use the RS cable's Dsub9 connector
SANYO : LP-XW200 / LP-XW250 / LP-XW300
HITACHI : CP-X308J / CP-X417J / CP-X3010J / CP-X2510J
NEC : NP600SJ / NP500WSJ / NP215J / NP210J / NP115J / NP110J
EPSON : EB-410W / EB-826W / EB-825 / EB-85
SHARP : PG-F255W / PG-F312X / PG-F212X
Canon : LV-7375 / LV-7370 / LV-7275 / LV-8300
EIKI : LC-XS25D / LC-XS30D
InFocus : IN2100 / IN2104EP
2. Use the RS cable's MiniDIN8 connector
SANYO : LP-XW60 / LP-XW65 / LP-WXL46
EIKI : LC-XB42D
The command table can be changed using the supplied programming tool.
To use the programming tool, a programming cable (sold separately) is required to
connect the Computer on which the programming tool is installed to the unit.
To purchase, contact your local dealer.
If your projector is not in the recommended list or it does not have a control
connector, control it using IR.
Caution
If you cannot make it operate properly, contact your local dealer.
28