Controlling With Rs-232C - Elmo CRC-1 Instruction Manual

Controlling with RS-232C

RS-232C protocol is used in control communication with the projector. Eight preset
command tables for projectors are available in the unit. Select the correct command table
that is suitable for your projector. The factory setting for the command table of the unit is
SANYO.
Command control for RGB applies when the unit is connected to the RGB1
connector of a projector. If a projector has multiple RGB connectors, connect
Caution
the cable to RGB1.
■ Procedure for selecting a preset table
While pressing and holding the unit's
(OFF) button (3 seconds), insert the AC Adapter.
When the buttons are released, all the LEDs other than PROGRAMMING
MODE flash and turn off.
16
(ON) button and