Andrew OM24SNG-RC Operation And Maintenance page 19

Caution
New Threadlocker Must Be Applied To the Brake Nut Setscrews To Prevent
Premature Brake Failure!
Step 4
Step 5
Protective
Tubing
Install new brake body on 8-32 studs until seated on brake nut and flush as
detailed in Figure 4. After disc is centered brake nut may be rotated slowly
to allow brake nut to line up with brake disc. Install 8-32 nuts and tighten -
threadlocker is not required on these nuts.
Brake
Body
Remove the two black wires from the old brake body from their wirenuts
(attached to the red and black wires). Install the new brake body wires in the
same manner as the old ones were removed. Either black brake wire may be
connected to either the red or black wires - polarity is not important. Be sure not
to reverse the wiring of the diode. (POLARITY DOES MATTER ON THE
DIODE). Be sure wire nut setscrews are secure. Refer to Figure 5 for details of
this step.
19
Brake Release
Hardware
8-32
Nuts
Figure 4
Squeeze-Tight
Black
Wire
Cover
Figure 5
Component Replacement
Brake
Cover
Fitting
Red
Wire