Set Mode - Spectracom 8183A NETCLOCK Instruction Manual

Section 4: Software Commands
4.17

SET MODE

This command is used to read or enter Set Mode operation. As a safeguard, the unit
must be placed into Set Mode whenever operational parameters are entered. The unit
"times out" of Set Mode and returns to Read Mode operations if no commands are
issued for 15 minutes. To read the Set Mode status ( ON or OFF), issue the SM
command as shown below:
Type:
Response:
To place the unit into Set Mode:
Type:
Response:
To return the unit to Read Mode:
Type:
Response:
Page 4-26
SM <ent>
SET MODE ON
or
SET MODE OFF
SM ON <ent>
SET MODE ON
SM OFF <ent>
SET MODE OFF
NetClock/GTP Instruction Manual