System Installation Checklist - Exacq Vision User Manual

1

System Installation Checklist

Quick Start
Installation
See the server's Quick Start Guide for information on installing the hardware.
Establishing Initial Communications
See the server's Quick Start Guide for information on establishing initial communications from the client software to an
exacqVision Server.
Configure IP Cameras
See the IP Camera Quick Start Guide for information on configuring the camera IP addresses, usernames, and passwords.
This document can be found at http://www.exacq.com/support/specsheets.html.
Config (Setup) Page (see Chapter 4)
System*
Set exacqVision server for static IP address.
Configure the system name, time, and time zone.
Storage
Ensure all disks are selected for recording except the system drive ("C:\" in Windows or
Ensure total disk space matches the expected value.
Add IP Cameras
Add IP cameras to the exacqVision servers.
Camera Recording (IP cameras)
1
Set resolutions .
1
Set frame rate .
Camera Recording (analog cameras)
1
Set resolutions .
1
Set frame rates .
Disable cameras that are not connected.
Serial Port
Set up serial port for RS-485 mechanical PTZ control.
Set up serial port for input from serial devices.
www.exacq.com
+1.317.845.5710
+5255.56080817
+44.1438.310163
6
"/mnt/edvr/0" in Linux)
USA (Corporate Headquarters)
Mexico
Europe/Middle East/Asia