Features and Specifications
Very low latency Audio / SD and HD Video transmission over Ethernet networks
Send video from multiple sources to multiple destinations over the same Ethernet network
Adjustable bandwidth
Receivers can select which source transmitter to display using pushbutton and OSD
Standard 38 kHz IR remote control repeater from receiver back to transmitter
Accepts VGA and DVI‐D input signals, including HDMI (NOTE: HDCP and digital audio are not supported,
and requires DVI‐HDMI adapter, not included)
Accepts stereo audio input
Works with any computer operating system
Remote On/Off switch at transmitter disables peripherals connected to receiver
Relays mic input from receiver back to transmitter
Transmitter accepts video resolutions from 640 x 480 to 1920 x 1080, from 60Hz to 70Hz refresh
Built‐in scaler scales output video to display's capability regardless of input video resolution
Receiver output resolutions and frame rates are as follows:
640 x 480
o
720 x 480
o
720 x 576
o
800 x 600
o
1024 x 768
o
1280 x 720
o
1280 x 1024
o
Receiver outputs both DVI‐D and VGA signals, regardless of input signal on transmitter
Built‐in browser‐based configuration for easy user‐setting of "Operational IP address" and device naming
Permanent, hard‐coded "Setup IP address" are as follows:
Transmitter (PCA)
o
Receiver (TVA)
o
STATUS LED colors:
Off
o
Green
o
Blinking green
o
Orange/Red
o
POWER LED colors:
Off
o
Green
o
Red
o
Blinking Red
o
Orange
o
70 fps
60 fps
50 fps
70 fps
60 fps
30 fps
30 fps
192.168.168.21
192.168.168.22
No network connection
Network connected
Network activity
High network bandwidth usage
Unpowered
Powered on and connection established with corresponding TX or RX unit
Powered on, but no connection to corresponding TX or RX unit
Reset button held down, ready to enter Setup mode
Unit is in Setup Mode
1360 x 768
30 fps
o
1400 x 1050
30 fps
o
1440 x 900
30 fps
o
1600 x 1200
30 fps
o
1680 x 1050
30 fps
o
1920 x 1080
25 fps
o
Need help?
Do you have a question about the InternetVue DT11‐KIT and is the answer not in the manual?