atBox Technology InternetVue DT11‐KIT User Manual page 12

At this point, yo A
m monitor will on nly work if the
L Lastly, power u up the unit by p
S STATUS LED sh
2.3. D DT70 Transmitt
E Ethernet switch
s seven other DT T11 devices dir
DT70
2.4. R Repeat steps 2
ou can also plu ug in a local VG
input signal is
DT11‐TX
plugging in it's
ould be GREEN N.
ter: The e DT70‐TX is id
h with IGMP sn nooping, desig
rectly into the D
0‐TX
.1 to 2.3 above e for all DT11 /
GA monitor to t the transmitte
also VGA.
power adapte er. The POWER
DT11‐TX D
entical as the D DT11‐TX, exce
ned specificall y for use with
DT70‐TX, witho out the need fo
D DT11‐RX
Direct t to receivers
A AND/OR
To ot her switches
/ DT70 devices that would be
er. But note th at the local VG
R LED should b be RED, and the
pt that it has a a built‐in 7‐port
multiple DT11 1 units. You ca
or additional n network hardw
DT11‐R
DT11‐R
e in use.
GA
e
t
n plug
ware.
RX
RX