Table of Contents
Advertisement
Table of Contents
Warnings & Important Information_____________________________________________________ 3
Professional & Professional Integrated Side-by-Side
Dimensions & Specifications (Professional Integrated 42" & 48") _______________________6
Cutout Dimensions (48")_________________________________________________________ 10
Professional & Professional Integrated Bottom-Mount
Dimensions & Specifications (36")_________________________________________________ 12
Cabinet Information (Professional) ____________________________________________________ 16
Cabinet Information (Professional Integrated) __________________________________________ 18
Anti-Tip Dimensions (42")________________________________________________________ 23
Cutout Dimensions (48")_________________________________________________________ 24
Dimensions & Specifications (36")_________________________________________________ 26
Cutout Dimensions (36")_________________________________________________________ 28
Cabinet Information (Designer)_______________________________________________________ 30
Custom Side Panel Dimensions (Professional)__________________________________________ 32
Custom Side Panel Dimensions (Designer & Professional Integrated) _____________________ 33
General Information ________________________________________________________________ 34
Unpacking & Moving _______________________________________________________________ 36
Installation_________________________________________________________________________ 37
Hinge Adjustment ______________________________________________________________ 38
Kickplate Installation ____________________________________________________________ 40
Door Stop Adjustment __________________________________________________________ 41
Water Filter Installation __________________________________________________________ 42
System Specifications and Data___________________________________________________ 43
Final Installation ________________________________________________________________ 44
Performance Checklist ______________________________________________________________ 45
Control Panels _____________________________________________________________________ 46
Service & Registration_______________________________________________________________ 47
2
IMPORTANT-
Please Read and Follow!
• Make sure that incoming voltage is the same
as unit rating. An electric rating plate
specifying voltage, frequency, wattage,
product.
• To reduce the risk of fire, electric shock, or
injury to persons, installation work and
electrical wiring must be done by qualified
people in accordance with all applicable
codes and standards, including fire-rated
construction.
• The installer should leave these instructions
with the consumer who should retain them
for local inspector's use and for future
It is your responsibility to:
• Comply with installation specifications and
dimensions
• Properly install unit
• Remove any moldings or decorative panels
that prevent the unit from being serviced
• Make sure that you have these materials (not
provided with your unit), which are necessary
for proper installation:
•1/4" (6 mm) copper tubing with shutoff
valve
•6- #8 x 3" (7.6 cm) wood screws (longer
screws may be required)
•1- saddle valve (do not use self-piercing
• Assure that floor will support unit, door
panels and contents (approximately 1200
pounds [540 kg])
• Provide a properly grounded electrical outlet
• Assure that location will permit appliance
doors to open 90˚ minimum
W A R N I N G
ELECTRICAL SHOCK
HAZARD
Disconnect power or turn
power disconnect switch to
OFF position before removing
top grille. Failure to do so can
result in death or electrical shock
Most of the unit's weight is at the top. Extra care is needed when moving the unit to prevent
tipping. Use cardboard shipping material or plywood under unit until it is installed in the
operating position to protect floor surface.
3
Your safety and the safety of others is
very important.
We have provided many important safety
messages in this manual and on your
appliance. Always read and obey all
safety messages.
This is the safety alert symbol. This
symbol alerts you to hazards that
can kill or hurt you and others.
All safety messages will be preceded by the
safety alert symbol and the word"DANGER"
or "WARNING." These words mean:
D A N G E R
You will be killed or seriously injured if
you don't follow instructions.
W A R N I N G
You can be killed or seriously injured if
you don't follow instructions.
All safety messages will identify the
hazard, tell you how to reduce the chance
of injury, and tell you what can happen if
the instructions are not followed.
W A R N I N G
TIP OVER HAZARD
Appliance is top
heavy and tips easily
when not completely
installed. Keep doors
closed until appliance
is completely installed
and secured per installation instructions.
Use two or more people to move and
install appliance. Failure to do so can
result in death or serious injury.
Hide quick links:
Advertisement
Table of Contents
