Roper Chimney Termination; Ny Solid Or Liquid Fuel Appliances Vented Into This Chimney Channel - Goodman MH8 Installation Instructions Manual

E
Proper Chimney
Termination?
(Check 1)
Chimney channel
free of solid and
liquid fuel
appliances?
(Check 2)
Crown in good
condition
(Check 3)
Cleanout free of
debris?
(Check 4)
Liner in good
condition?
(Check 5)
Dilution air
available?
(Check 6)
Complete the
installation.
(Check 7)
C 1 - P
HECK

ROPER CHIMNEY TERMINATION

A masonry chimney used as a vent for gas fired equipment
must extend at least three feet above the highest point where it
passes through the roof. It must extend at least two feet higher
than any portion of a building within a horizontal distance of 10
feet. In addition, the chimney must terminate at least 3 feet
above any forced air inlet located within 10 feet. The chimney
must extend at least five feet above the highest connected equip-
ment draft hood outlet or flue collar.
XTERIOR MASONRY
Change venting
arrangements
(Fix 2)
Rebuild crown
(Fix 3)
and/or Reline
(Fix 4)
Reline
(Fix 4)
Reline
(Fix 4)
Reline
(Fix 4)
.
C - C
HIMNEYS ATEGORY
If the chimney does not meet these termination requirements,
but all other requirements in the checklist can be met, it may
be possible for a mason to extend the chimney. If this will not
be practical, see Fix 1.
2' Min.
Termination 10 Feet Or Less From Ridge, Wall or Parapet
Wall or
Parapet
Ridge
Termination More Than 10 Feet From Ridge, Wall or Parapet
C 2 - A
HECK NY SOLID OR LIQUID FUEL APPLIANCES VENTED
INTO THIS CHIMNEY CHANNEL
Solid fuel appliances include fireplaces, wood stoves, coal fur-
naces, and incinerators.
15
I F
URNACES
10' or Less
2' Min.
3' Min.
Wall or
Parapet
Chimney
10' or Less
2' Min.
3' Min.
Chimney
More than 10'
3' Min.
NOTE: No Height
above parapet
required when distance
Chimney
from walls or parapet is
more than 10 feet.
More than 10'
Height above any
roof surface within
10 feet horizontally.
10'
2" Min.
3' Min.
Chimney
O
NLY