Advanced Settings; Parameter Settings - Silvan Selecta Selecta MANSECURE01 Instruction Manual

If the moving object continually enters into the area of the main sensor, the camera takes pictures immediately,
therefore catching the whole body of the game. This split-second process could be as short as 0.2 second. In the case
set up situations where the object moves within the area of the prep (side) sensors, to avoid the camera being powered
on constantly, the system is designed to work in the following way: If the game does not enter the area of the main
sensor and therefore not trigger the main sensor, the camera will power off after 3 seconds. If the trigger events
consecutively happened twice only in the PIR area of the prep (side) sensors, the camera will not activate, but only by
the main sensor. So later on when the object enters the PIR area of the main sensor eventually, since it is not in fast
movement, the picture will by all means capture the whole body of the game based on our standard 1 second response
time.
The Scouting camera trail camera comes with preset manufacturer settings. You can change the settings to meet your
requirements. Please make sure the camera is in the test mode.

3.1 Parameter Settings

Press "MENU" key to enter/exit the menu. Press
to confirm the change. Always remember to press
setting.
Parameter
Mode
Format
Photo Size
(affects still photos
only)
Video Size
(affects video
clips only)
Set Clock
Picture No.
(affects still
photos only)
Video Length
(affects video clips
only)
Interval
Sense Level
(of PIR motion
sensors)

ADVANCED SETTINGS

Settings
(Bold = default)
Camera,
Video,
Camera+Video
Enter
1MP, 3MP,
5MP, 8MP,
12MP available
1280 x 720
720 x 480
640 x 480,
320 x 240
Enter
01 Photo, 02
Photos, 03
Photos
Optional from 1s to 60s.
Default is 10s
1 Min,
optional from
1S to 60M
Normal,
High,
Low
, to move the marker,
to save the change. Otherwise you will lose your new
Description
Select whether still photos or video clips are taken. In
Camera+Video mode, can first take photos and then shoot
videos afterward
All files will be deleted after formatting the SD card. Highly
recommend you format the SD card if it has been used
previously in other devices. Caution: make sure wanted files on
the SD card have been backed up first!
Select desired resolution for still photos in mega pixels. Note:
Lower resolution setting allows for smaller file size and faster
camera reaction speed. High resolution photos require more time
to record to memory hence slower camera reaction speed
Select video resolution (pixels per frame). Higher resolution
produces better quality videos, but creates larger files that take
more of the SD card capacity.
Press Enter to set up date and time Note: The Time must be set
every time batteries are changed or temporarily removed
Select the number of photos taken in sequence per motion event
triggering the Camera.
Videos are in AVI format that can be played back on most video
Players (or on the camera).
A high Interval prevents the SD card from filling up with too
many redundant images when there is a lot of repeat activity i.e.
animal standing at a watering trough. A low interval reduces the
chance of missing activity but increased chance of recording too
many photos using memory and battery life.
Select the sensitivity of the PIR sensor. The High setting suits
indoors and environments with little interference, while the
Normal/Low suits outdoors and environments with more
interference. Temperature also affects the sensitivity. The High
setting is suitable when the ambient temperature is warm, and
the Low setting is helpful in cold weather.
, to change the setting, and