Din Front-Mount; Din Rear Mount; Fastening The Front Panel - Pioneer DEX-P99RS Installation Manual

Installation

DIN Front-mount

Installation with the rubber bush
1. Insert the mounting sleeve into the
dashboard.
• When installing in a shallow space, use a
supplied mounting sleeve. If there is enough
space behind the unit, use factory supplied
mounting sleeve.
2. Secure the mounting sleeve by using
a screwdriver to bend the metal tabs
(90°) into place.
3. Install the unit as illustrated.
Dashboard
Mounting sleeve
Screw
4. Attach the trim ring.
Note
• Attach the trim ring with the grooved side facing
down.
Removing the Unit
1. Insert the supplied extraction keys
into both sides of the unit until they
click into place.
2. Pull the unit out of the dashboard.
Rubber bush

DIN Rear mount

1. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
2. Tighten two screws on each side.
• Use either truss screws (5 mm × 8 mm)
or flush surface screws (5 mm × 9 mm),
depending on the shape of screw holes in the
bracket.
Factory radio mounting bracket

Fastening the front panel

If you do not plan to detach the front panel,
the front panel can be fastened with supplied
screw.
Fixing screw
Screw
Dashboard or
Console
Release knob
11