Installation; Din Front/Rear-Mount - Pioneer DVH-P4100UB Installation Manual

Installation

Note:
• Check all connections and systems before final
installation.
• Do not use unauthorized parts. The use of
unauthorized parts may cause malfunctions.
• Consult with your dealer if installation requires
drilling of holes or other modifications of the
vehicle.
• Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
•
Optimum performance is obtained when the unit
is installed at an angle of less than 30°.
• When installing, to ensure proper heat dispersal
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.

DIN Front/Rear-mount

Removing the Unit
1. Extend top and bottom of the trim ring outwards
This unit can be properly installed either from
to remove the trim ring. When reattaching the
"Front" (conventional DIN Front-mount) or
trim ring, push the trim ring onto the unit until it
"Rear" (DIN Rear-mount installation, utilizing
clicks. (If the trim ring is attached upside down,
threaded screw holes at the sides of unit chassis).
the trim ring will not fit properly.)
For details, refer to the following installation
• It becomes easy to remove the trim ring if the
methods.
front panel is released.
DIN Front-mount Trim ring
Installation with the rubber bush
Mounting sleeve
Dashboard
182 1 1 1 82
2. Insert the supplied extraction keys into both sides
Rubber bush
53 53
of the unit until they click into place.
3. Pull the unit out of the dashboard.
Screw
1. Insert the mounting sleeve into the dashboard.
•
When installing in a shallow space, use a sup-
plied mounting sleeve. If there is enough
space behind the unit, use factory supplied
mounting sleeve.
2. Secure the mounting sleeve by using a screwdriv-
er to bend the metal tabs (90°) into place.
3. Install the unit as illustrated.
<ENGLISH>
DIN Rear-mount
1. Extend top and bottom of the trim ring outwards
to remove the trim ring. When reattaching the
trim ring, push the trim ring onto the unit until it
clicks. (If the trim ring is attached upside down,
the trim ring will not fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
Trim ring
2. Determine the appropriate position where the
holes on the bracket and the side of the unit
match.
3. Tighten two screws on each side.
Use either truss screws (5 mm × 8 mm) or
•
flush surface screws (5 mm × 9 mm), depend-
ing on the shape of screw holes in the
bracket.
Screw
Dashboard or Console
Factory radio mounting bracket