Electrical Connection - Miele Ventilation System Operating And Installation Instructions

,WARNING
TO REDUCE THE RISK OF
FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
All electrical work should be
performed by a qualified electrician
in strict accordance with national
regulations (for USA: ANSI-NFPA
70) and local safety regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous.
Ensure that power to the appliance
is OFF while installation or repair
work is performed.
^ Verify that the voltage, load and
circuit rating information found on the
data plate (located behind the
grease filter), match the household
electrical supply before installing the
hood.
^ Use only with ventilation hood
cord-connection kits that have been
investigated and found acceptable
for use with this model hood.
If there is any question concerning the
electrical connection of this appliance
to your power supply, please consult a
licensed electrician or contact Miele's
Technical Service Department. See
back cover for contact information.
,WARNING:
THIS APPLIANCE MUST BE
GROUNDED

Electrical connection

Grounding Instructions
This appliance must be grounded in the
event of an electrical short circuit
grounding reduces the risk of electric
shock by providing a path of least
resistance.
WARNING - Improper grounding can
result in a risk of electric shock.
If there is any doubt, have the electrical
system of the house checked by a
qualified electrician.
Do not use an extension cord. If the
power cord is too short, have a
qualified electrician, install an outlet
near the appliance.
Important
The hood comes equipped with a 5.9 ft
(1.8 m) power cord.
The hood must be hard wired
accordingly:
Black/Red wire:
White wire:
Green wire: connect to GND (ground)
connect to L1 (live)
connect to N (neutral)
29