Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
Telephone base installation
•
Plug the large end of
the telephone base
power adapter into
a power outlet not
controlled by a wall
switch.
•
Raise the antenna.
Charger installation
IMPORTANT INFORMATION
1. Use only the power adapters supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
For more detailed instructions, refer to the online Complete user's manual at
www.telephones.att.com/manuals.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Telephone line cord
•
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
5
•
Plug the other end of the telephone line
cord into a telephone jack or a DSL filter.
•
Plug the power
adapter into a power
outlet not controlled
by a wall switch.
If you have DSL
high-speed Internet
service, a DSL filter
(not included) is
required. The DSL
filter must be
plugged into the
telephone wall jack.
Route the power
adapter cord and the
telephone line cord
through the slots.
•
Plug one end of the
telephone line cord
into the telephone
jack on the back of
the telephone base.
•
Plug the small end of
the telephone base
power adapter into
the power adapter
jack on the back of
the telephone base.
or call
.