Chapter 1 - Configuration; Connecting With A Wired Connection; Connecting To A Wireless Connection; Select Wireless Access Point From Settings - Buffalo LPV4-U2-300S User Manual

Chapter 1 - Configuration

Connecting with a Wired Connection

The print server can be set up using a wired connection. Refer to the procedures below. The print server cannot use both
a wired and a wireless connection at the same time.
1
Connect the print server to an access point using an Ethernet cable.
2
Connect the AC adapter to the print server.
3
After it powers on, check the side of the print server.

Connecting to a Wireless Connection

There are three ways to connect the print server to a wireless connection: selecting the wireless access point from print
server's Settings, WPS PIN method, or WPS push-button method. Refer to the procedures below.
The print server cannot use both a wired and a wireless connection at the same time. WPA2-PSK (TKIP) encryption is also
not supported.

Select Wireless Access Point from Settings

Once the print server is connected to a wired network, you can manually select the wireless access point to connect to
from the print server's Settings. To open Settings, refer to the "Accessing Settings" section below.
Before starting, the print server's connection method should be set to "Auto". The access point should also have SSID
broadcast enabled and is not using WPA2-PSK (TKIP) encryption. Refer to Chapter 4 for more information.
1
Set up the print server on a wired connection then log in to Settings.
2
Navigate to Network - Wireless LAN.
5