THUNDER TIGER ZK2 Instruction Manual page 4

The RS Receiver/ ESC (Electric Speed Control) Module
1. Receiver & ESC:
2. Crystal:
3. Power Switch:
4. Antenna Holder/Tube: Mounts the antenna tube as a transmitter's link.
5. Power Harness Plug: Connects the battery pack to the unit.
6. Steering Servo Socket:Connects the steering servo to the unit.
7. Motor Plug:
Frequency
The RS AM Module can be used with 26, 27 or 40 MHz frequency band to operate your vehicle. Each
band has 6 different channels available allowing users to change the crystals for versatile operating at the
same time. When changing the crystal, just replace a set of crystal plugging on transmitter and on
receiver simultaneously by pulling it out. Then push a new set of crystal into the socket carefully on the RS
module and Transmitter respectively. (Caution: do not bend the two pins of the crystal or it would cause
damage of your model.) The following frequency channels are available at 27MHz band.
CHANNEL FREQUENCY
BAND
CH1 26.995 MHz
CH2 27.045 MHz
CH3 27.095 MHz
CH4 27.145 MHz
CH5 27.195 MHz
CH6 27.255 MHz
Receives the signal from the transmitter to control your vehicle and control the
power input and rotating direction of the motor.
To change the channel it receives
Sliding to turn the unit on or off.
Connects the motor to the unit to get power supply.
6
FLAG THUNDER TIGER
COLOR
Brown Flag
Red Flag
Orange Flag
Yellow Flag
Green Flag
Blue Flag
2 1
Each frequency is assigned a colored
PART NO.
flag and channel number. Attach this
AQ0311
flag to the end of your transmitter
AQ0312
antenna so that other modelers can
deter mine your frequency from a
AQ0313
distance. This is very important since
AQ0314
it is not possible for more than one
model to operate on the same
AQ0315
frequency at the same time.
AQ0316
3
4
7
3
5