Removing A Memory Media; Additional Memory Module - Toshiba DX 730 User Manual

Removing a memory media

The following instructions apply to all types of supported media devices. To
remove a memory media, follow the steps as detailed below:
1.
2.
3.
4.

Additional memory module

You can install additional memory into the computer in order to increase
the amount of system memory that is available. This section describes how
to install and remove optional memory modules.
User's Manual
Do not turn the computer off or switch to Sleep Mode or Hibernation
Mode while files are being copied - doing so may cause data to be
lost.
Open the Safely Remove Hardware and Eject Media icon on the
Windows Taskbar.
Point to memory media and click it.
Press the memory media to partially extend it out of the computer.
Grasp the media and remove it.
If you remove the memory media or turn off the power while the
computer is accessing the memory media, you may lose data or
damage the media.
Do not remove the memory media while the computer is in Sleep or
Hibernation Mode. The computer could become unstable or data in
the memory media could be lost.
Do not remove only the miniSD/microSD Card while leaving the
adaptor in the Memory media slot.
When installing or removing a memory module, you must ensure that
you do not touch any other internal areas of the computer.
Insert the two memory modules into Slot A and Slot B respectively.
The computer will operate in dual channel mode. You can access the
inserted memory modules efficiently in dual channel.
Use only memory modules approved by TOSHIBA.
3-33