Panasonic AG-MYA30G Operating Instructions Manual page 2

EMC NOTICE FOR THE PURCHASER/USER OF THE APPARATUS
1. Applicable standards and operating environment (AG-MYA30G)
The apparatus is compliant with:
• standards EN55103·1 and EN551 03-2 1996.11, and
• electromagnetic environmenls E1, E2, E3 and E4
2. Pre-requisite conditions to achieving compliance with the above
standards
<1> Peripheral equipment to be connected to the apparatus and special
connecting cables
• The purchaser/user is urged to use only equipment which has been
recommended by us as peripheral equipment to be connected to the apparatus.
• The purchaser/user is urged to use only the connecting cables described below.
<2> For the connecting cables, use shielded cables which suit the intended
purpose of the apparatus.
• Video signal connecting cables
Use double shielded coaxial cables, which are designed for 75-ohm type high-
frequency applications, for SOl (Serial Digital Interface).
Coaxial cables. which are designed for 75-ohm type high-frequency
applications, are recommended for analog video signals.
• Audio signal connecting cables
If your apparatus supports AES/EBU serial digital audio signals, use cables
designed for AES/EBU.
Use shielded cables, which provide quality performance for high-frequency
transmission applications, for analog audio signals.
• Other connecting cables (IEEE1394, USB)
Use shielded cables, which provide quality performance for high-frequency
applications, as connecting cables.
• When connecting to the DVI signal terminal, use a cable with a ferrite core.
• If your apparatus is supplied with ferrite core(s), they must be attached on
cable(s) following instructions in this manual.
3. Performance level
The performance level of the apparatus is equivalent to or better than the performance
level required by these slandards.
However, the apparatus may be adversely affected by interference
if
it is being used
in an EMC environment, such as an area where strong electromagnetic fields are
generated (by the presence of signal transmission towers, cellular phones, etc.). In
order to minimize the adverse effects of the interference on the apparatus in cases
like this, it is recommended that the following steps be taken with the apparatus being
affected and with its operating environment:
1. Place the apparatus at a distance from the source of the interference.
2. Change the direction of the apparatus.
3. Change the connection method used for the apparatus.
4. Connect the apparatus to another power oullet where the power is not shared
by any other appliances.
EEE Ybnetmeligine Uygundur.
EEE Complies with Directive of Turkey.
E-1