Download Print this page

Defender Security Mini Alarm MA-20 Owner's Manual

Mini alarm, motion detector with keypad

Advertisement

Quick Links

Mini Alarm
Mini Alarm, Motion Detector
with Keypad
LOCATION OF CONTROLS
Motion Sensor
2 Speaker
3. Keypad
4. Battery Low LED
BATTERY INSTALLATION (SEE FIGURES BELOW)
removing the screw on the bottom of the unit and lifting the
bottom of the back cover as shown in the figure below. insert
four (4) "AA" size batteries (not included) following the
polarity diagram. When the last battery is inserted, the unit
properly. Replace the back cover. The Battery Low LED will
light when the batteries needs replacing. Because of this
unit's unique design, it does not require a battery cover.
6. Battery Compartment
PROGRAMMING THE ALARM.
Immediately after inserting the batteries, the desired 4 digit
code must be set. To set the code, select your 4-digit
access code, and simply press
keypad. NOTE: The alarm must be reprogrammed with
personal code every time the batteries
and replaced. After removing
number 4 before installing the n8w batteries.
INSTALLATION
Place the unit in the desired location,
preferably near the front or back door.
Remove the back cover and secure it to the
wall using the supplied screws (see figure at
right). The unit can now be snapp8d into place
onto the back cover and secured by replacing
the screw on the bottom of the unit. Thii unit is
also free standing.
OPERATION
When leaving the protected area, press
keypad number 4 and a confirmation tone
30 seconds to enable you to leave the protected area
before the alarm sounds. If the unit detects motion, it will
sound an alarm.
When returning to the protected area, simply press your
personal alarm code within 10 seconds. This will disarm
the unit. The 10 second delay enables you to get to the
alarm before it sounds.
EXTERNAL SIREN ,SOCKET
socket is used to connect an external siren unit {not
included).
CARE AND MAINTENANCE
To clean the unit housing, use a soft cloth slightly
dampened with water and wipe dry.
thinner for cleaning, otherwise the case may be deformed or
discoiored.
OWNER'S MANUAL
MODEL
MA-20
desired 4 dig-&Ion the
are removed
the
press button
batteries,
REV i/96,4/96

Advertisement

loading
Need help?

Need help?

Do you have a question about the Mini Alarm MA-20 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Defender Security Mini Alarm MA-20

  • Page 1 Mini Alarm OWNER’S MANUAL MODEL MA-20 Mini Alarm, Motion Detector with Keypad PROGRAMMING THE ALARM. LOCATION OF CONTROLS Immediately after inserting the batteries, the desired 4 digit code must be set. To set the code, select your 4-digit access code, and simply press desired 4 dig-&Ion the...
  • Page 2 MINI ALARM MODEL MA20 BEDIENUNGSANLEITUNG MA 20 UND NEHMEN SIE DEN HINTEREN GEHÄUSEDECKEL AB. INSTALLIEREN SIE DIE VIER AA BATTERIEN. NACH DEM EINLEGEN DER VIERTEN BATTERIE BESTÄTIGT DIE MA 20 DIE RICHTIGE HINTEREN GEHÄUSEDECKEL. DIE ROT PROGRAMMIERUNG: SOFORT NACH DEM EINLEGEN DER VIER AA BAI-I-ERIEN PROGRAMMIEREN SIE DURCH DIE EINGABE IHRER 4-STELLIGEN FREI WAHLBAREN GEHEIMZAHL INDIVIDUELL IHRE MA20 (NACH JEDEM ENTFERNEN DER BATTERIEN...