Table of Contents
Advertisement
MAINTENANCE
DISPLAY CONSOLE MAINTENANCE:
Clean with a soft damp cloth, do not use caustic cleaners or
abrasives as these will damage the finish on the display console.
Keep away from dust and dirt and moisture, dust ventilation ports
regularly with a gentle puff of air, this will keep the indoor
temperature and humidity accurate.
INTEGRATED WIRELESS SENSOR MAINTENANCE:
Clean the housing with a damp cloth, do not use abrasive cleaners
or any materials that will mar the polished surfaces of the rain
collection funnel or the solar panel- this will result in decreased
performance and reliability.
Occasionally remove the rain collector screen cup and empty it. This
will filter out seeds and small sticks, etc. (the rain collector screen cup
is located within the rain funnel- remove from the top gently by
squeezing and pulling out).
Remove any foreign matter on the outside of the housing to allow for
free movement of wind vane and anemometer.
INSECTS: in most cases, insects will not pose a problem. However, in
some instances, insects may cause repeated obstructions to weather
measurement by nesting or building homes in or on the integrated
wireless sensor. In these cases, it may help to spray the housing with
a commercially available home insect guard/repellent product (not
included) to limit the problem. Please consult the insect repellent
manufacturers instructions and safety information before using.
BATTERY SAFETY:
Clean the battery contacts and also those of the device prior to
battery installation. Remove batteries from equipment which is not to be used for an
extended period of time. Follow the polarity (+/-) diagram in the battery
compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended
are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in
fire, as batteries may explode or leak. DO NOT mix old and new batteries or types
of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT
recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
26
TROUBLESHOOTING
Problem
Relocate the main unit and/or the wireless
sensor. Both units must be within 330 feet
Bad
(100m) from each other. Make sure both
units are placed at least 3 feet (.91 m) from
Wireless Sensor
other electronic appliances and devices that
Reception
may interfere with the wireless
communication (such as TVʼs, microwaves,
computers etc). NOTE: It may take up to 20
minutes for the main unit to re-synchronize
no bars
with the sensor when batteries are replaced.
Use lithium batteries in sensor when
temperature is below -4ºF (-20ºC).
If wireless reception is bad (no bars), see
No Wireless Sensor Data
"Bad Reception" section above. The wireless
(no communication)
ID setting on each unit must match for all
no bars and flashing
units to communicate properly. See "Set
" -- " data
Wireless ID" on the next page.
Batteries may need replacing
Display Console
Check that AC adaptor is fully inserted if
Screen Not Working
running off AC power only
Check that the USB cable is securely
USB Connectivity
connected to the display console AND to
is not working
your PC USB port.
Confirm that the correct mode is selected.
Check that the USB cable is securely
I Cannot Access
connected to the display console AND to
my Data Online or
your PC USB port.
from the APP
Confirm that USB mode 3 or 4 is selected.
Make Certain that the display console is
powered on.
Confirm your display console DEVICE I.D. /
M.A.C. number is entered into your online
account correctly at www.acu-link.com
Possible Solution
27
Advertisement
Table of Contents
