Programming And Setting The Water Hardness Level - Miele G 856 Operating Instructions Manual

Before using for the first time
Programming and setting the
water hardness level
Your water hardness level must be pro-
grammed into the dishwasher using the
buttons on the control panel. The water
hardness selector in the wash cabinet
must also be set to the water hardness
of your area.
Programming and setting the water
hardness level
^ Turn "Off" the dishwasher.
^ Turn the program selector to "Stop".
^ Hold the "Top Solo" button in and at
the same time turn "On" the dish-
washer with the "On/Off" button. After
2 seconds release the "Top Solo"
button.
The "Salt" indicator flashes.
Note:
If any other indicators flash the process
must be repeated.
Except:
If the "Rinse aid" indicator lights then
rinse aid was never added or needs to
be refilled.
14
^ Turn the water hardness level selec-
tor to your corresponding water hard-
ness(see table below).
gr/gal ppm
1 - 4 20 - 70
5 - 7 90 - 130
8 - 10 140 - 180
11 - 14 200 - 250
15 - 17 270 - 310
18 - 21 320 - 380
22 - 35 400 - 630
36 - 70 650 - 1260
The water hardness level selector is
preset to 1 - 4 gr/gal (20 - 70 ppm).
Example:
Water hardness level 20 gr/gal.
Turn program selector to the
6 o'clock position.
Selector Setting
Normal 55 °C/130 °F
Sani Wash
Normal 65 °C/150 °F
Light Wash 55 °C/130 °F
5 o'clock position
6 o'clock position
7 o'clock position
Energy Saver