Safety Information; Important Safety Instructions - Pace DC900X Installation Manual

SAFETY INFORMATION

This Home Content Sharing
TM
Attached Storage (NAS), has been manufactured and tested with your
safety in mind. However, improper use can result in potential electric
shock or fire hazards. To avoid defeating the safeguards that have been
built into the NAS, please observe the precautions discussed in this
document.
Warnings
To reduce the risk of electric shock, do not remove the cover of the NAS.
There are no user-serviceable parts inside it.
Do not perform any servicing unless you are qualified to do so. Refer all
servicing to qualified service personnel. Servicing the NAS yourself will
invalidate the warranty.
To reduce the risk of fire or electric shock, do not expose this NAS to rain
or moisture.
On the rear panel of the NAS there is a tamper-evident label that states
'Warranty void if broken or removed'.
To avoid possible damage to the internal hard disk, do not pick up or move
the NAS while it is powered up. If you want to move the NAS, first stop any
recording, then turn off the NAS and wait 60 seconds before disconnecting
it from its power supply unit. You should handle the NAS carefully, as any
damage you cause to the internal hard disk (or any other component) will
invalidate the warranty.
Installation
The installation of the NAS should be carried out by a qualified installer
and should conform to local codes.
Note to the installer
This reminder is provided to call the attention of the cable-TV-system
installer to Section 820 of the National Electrical Code (USA), which
provides guidelines for proper grounding and, in particular, specifies
that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as is practical.
Service address:
Pace Americas Inc.
3701 FAU Boulevard, Suite 200, Boca Raton, Florida 33431 U.S.A.
© 2009 Pace plc. All rights reserved.
(HCS) server, often known as Network
DC900X INSTALLER'S MANUAL (501-3434310) RELEASE 30th Oct. 2009

IMPORTANT SAFETY INSTRUCTIONS

Before you install or use the apparatus, you must read and
understand these Important Safety Instructions.
At all times when using the apparatus you must follow
these Important Safety Instructions to reduce the risk of fire,
electrical shock and injury to persons.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance
with the manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. If the provided plug does not fit into the outlet,
consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11. Only use attachments/accessories specified by the
manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified
by the manufacturer, or sold with the apparatus. When a
cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when
unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
3