Preparing For Home Content Sharing At Client Set-Tops; Enabling Home Content Sharing At Client Set-Tops; Programming The Remote Control For Home Content Sharing - Pace DC900X Installation Manual

PREPARING FOR HOME CONTENT SHARING AT CLIENT SET-TOPS

Enabling Home Content Sharing at client set-tops

You need to enable Home Content Sharing at each of the client set-tops. Instructions below relate to the UEI
Universal remote control. The button names might be different on other types of remote control.
1. Ensure the NAS and client set-top 3 are switched on and there is a picture on the TV that is attached client
set-top 3.
2. Press the POWER button on the set-top's remote control, then press the Menu button.
3. The PACE USER SETTINGS menu appears on the TV screen.
4. Press the U or D button to highlight Home Content Sharing, then press OK/Select.
5. Press the U or D button to highlight Enable, then press OK/Select.
6. Press the L button to redisplay the PACE USER SETTINGS menu.
7. Press the POWER button to remove the menu from the screen.
8. Repeat the above seven steps for client set-tops 1 and 2.
PACE USER SETTINGS
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Front Panel Settings
HDMI Settings
Home Content Sharing
Restore Defaults
Select[OK] Exit[POWER]

Programming the remote control for Home Content Sharing

Program the remote control for each of the client set-tops to give one-touch access to HCS functions.
Instructions below relate to the UEI Universal remote control.
Programming the B button - My Network
After you have programmed the B button, you can press it to display the My Network screen on the TV. This
screen gives you access, from any location within the HCS system, to all of the recorded content.
1. Press the CABLE button on the remote, then press and hold the SETUP button until the CABLE button
blinks twice.
2. Use the number buttons on the remote to enter the code 994. The CABLE button blinks twice.
3. Press (do not hold) the SETUP button, then use the number buttons to enter the code 00237.
4. Press the B button. The CABLE button blinks twice.
Programming the C button - Bulk Delete of titles within folders
After you have programmed the C button, you can use it, on the My Network screen, to delete several titles
within a folder at the same time.
1. Press the CABLE button on the remote, then press and hold the SETUP button until the CABLE button
blinks twice.
2. Use the number buttons on the remote to enter the code 994. The CABLE button blinks twice.
3. Press (do not hold) the SETUP button, then use the number buttons to enter the code 00114.
4. Press the C button. The CABLE button blinks twice.
OK
Select
OK
Select
DC900X INSTALLER'S MANUAL (501-3434310) RELEASE 30th Oct. 2009
Home Content Sharing
Enable
> Disable
OK
Select
Home Content Sharing
OK
> Enable
Select
Disable
13