Disconnecting The Cable; Usb Interface Configuration; Start-Up - Datalogic GryphonD432 Quick Reference Manual

Disconnecting the Cable

Disconnecting the Cable

USB Interface Configuration

The USB interface is compatible with:
Windows 98 (and later)
Mac OS 8.0 (and later)

Start-Up

As with all USB devices, on connection the Host performs several checks
by communicating with the Gryphon D432/D412Plus. During this
phase the green LED on the Gryphon D432/D412Plus blinks and nor-
mal operations are suspended. Two basic conditions must be met before
Gryphon D432/D412Plus is ready to read codes: the correct USB
driver must be loaded and sufficient power must be supplied to the reader.
For all systems, the correct USB driver for the default USB-KBD interface
is included in the Host Operating System and will either be loaded auto-
matically or will be suggested by the O.S. and should therefore be selected
from the dialog box (the first time only).
If the Host supplies sufficient power to the reader, the start-up phase ends
correctly, the green LED stops blinking and the reader emits the beep OK
signal.
If the Host does not supply sufficient power to the reader, a dialog box
will appear on the Host and the reader will be blocked (green LED con-
tinues blinking). In this case, disconnect the USB cable at the Host (green
LED stops blinking), connect and power-up an external supply to USB
cable, then reconnect the USB cable to the Host and close the dialog box.
The reader emits the beep OK signal. You can now read codes.
8
IBM POS for Windows
4690 Operating System
Gryphon™ D432/412Plus