Service Access - Jacuzzi DESIGNER BATH SERIES Installation & Operation Instructions

Service Access

For partially or fully sunken installations, allow for ac-
cess to service connections. It is the installer's respon-
sibility to provide sufficient service access. The recom-
mended minimum dimensions allowable for service to
the bath are shown in the "Service Access" illustration.
Provide adequate area around unit for air circulation
for cooling the motor and to supply sufficient air to the
jets. Do not insulate this area or around motor.
SERVICE ACCESS
(WITHOUT SKIRT)
12"
ALTERNATE
ACCESS
18"
Service Access
(Corner Tubs)
For partially or fully sunken installations, allow for ac-
cess to service connections. It is the installer's respon-
sibility to provide sufficient service access. The recom-
mended minimum dimensions allowable for service to
the bath are shown in the "Service Access" illustration.
Provide adequate area around unit for air circulation
for cooling the motor and to supply sufficient air to the
jets. Do not insulate this area or around motor.
SERVICE ACCESS
(CORNER BATHS)
18"
C
36"
RIGHT HAND UNIT SHOWN
A - Preferred access
B - Acceptable alternative if access A is not possible
C - Additional access for equipment (Optional)
INSTALLATION INSTRUCTIONS
12"
18"
PREFERRED
MOTOR
ACCESS
20"
A
B
24"
15
The Duetta Whirlpool baths should access as shown
below.
DUETTA SERVICE ACCESS
(WITHOUT SKIRT)
HEATER
FRONT
12"
PREFERRED
ACCESS
18"
The Allusion Whirlpool baths should access as shown
below.
ALLUSION SERVICE ACCESS
HEATER
FRONT
12"
18"
ALTERNATE
ACCESS
In some cases, access may not have been provided
because of the design of the bath environment and hav-
ing full understanding that in this case, it may be neces-
sary to remove the unit for service.
If this is the case, diagnosing a problem may not be
possible without complete access to the plumbing sys-
tem. This would necessitate the removal of the unit.
Although this practice is not commonly implemented, it
is an acceptable method.
SERVICE ACCESS
AREA
In some cases access may have been provided in
Area A but service is required in Area B which requires
the unit to be pulled for service and reinstalled.
If service access has not been provided, it is the
home owners responsibility to remove the bath and
provide the required access, should a repair become
necessary.
Jacuzzi Whirlpool Bath K339000X 3/06
12"
18"
ALTERNATE
MOTOR
ACCESS
PUMP/MOTOR
12"
18"
PREFERRED
ACCESS
AREA
A
B
MOTOR