Control Panel Installation; Service Access - Jacuzzi FUZION BATH SERIES 7260 Installation & Operation Instructions

Control Panel Installation

For drop-in and undermount installations, install the control panel as shown below.
The control panel cutout opening in the assembled wood frame and tub and in the assembled counter and tub
must be clear and free of adhesive.
Control panel and wire to be free of defects. Insert wire into panel connector.
Apply adhesive sparingly around base of control panel.
Thread wire through cutout and to control box. Orientate control panel so that the Jacuzzi logo is read from the inside
of the tub. Lower control panel in cutout and press firmly to embed adhesive.
Connect wire to control box.

Service Access

For partially or fully sunken installations, allow for ac-
cess to service connections. It is the installer's respon-
sibility to provide sufficient service access. The recom-
mended minimum dimensions allowable for service to
the bath are shown in the "Service Access" illustration.
The recommended location(s) of the service access are
shown on the Rough-in drawings.
Provide adequate area around unit for air circulation
for cooling the motor and to supply sufficient air to the
jets. Do not insulate this area or around motor.
SERVICE ACCESS
(WITHOUT SKIRT)
HEATER
FRONT
12"
ALTERNATE
ACCESS
18"
INSTALLATION INSTRUCTIONS
Inside of tub
12"
18"
PREFERRED
MOTOR
ACCESS
15
Apply sparingly to
avoid squeeze out
Adhesive
In some cases, access may not have been provided
because of the design of the bath environment and hav-
ing full understanding that in this case, it may be neces-
sary to remove the unit for service.
If this is the case, diagnosing a problem may not be
possible without complete access to the plumbing sys-
tem. This would necessitate the removal of the unit.
Although this practice is not commonly implemented, it
is an acceptable method.
SERVICE ACCESS
AREA
In some cases access may have been provided in
Area A but service is required in Area B which requires
the unit to be pulled for service and reinstalled.
If service access has not been provided, it is the
home owners responsibility to remove the bath and
provide the required access, should a repair become
necessary.
Jacuzzi Whirlpool Bath DE99000A
Connect Blower
wire here
(Grey wire)
Connect Control Box
wire here
(Black wire)
Inside of tub
AREA
A
B
MOTOR
3/06