Maintenance Instructions - Jacuzzi DESIGNER BATH SERIES Installation & Operation Instructions

Designer/luxury bath series

Hide thumbs

Table Of Contents

Table of Contents

Suction/Intake Cover/Strainer Maintenance

Clean the suction/intake cover/strainer of hair and debris

when necessary. To do this, remove the center screw and

detach the square cover. Clean the cover by backflushing

debris from the holes. Replace the suction/intake cover im-

mediately after cleaning. When reinstalling, orient the cover/

strainer with the small notch at the bottom. The gasket must

be inserted into the groove of the cover/strainer before rein-

stalling onto the suction fitting.

CAUTION: Keep hair a minimum of 6 inches (15,2 cm)

away from the suction/intake fitting at all times when the

whirlpool system is operating. Hair longer than shoulder

length should be secured close to the head, or a bathing

cap should be worn. Do not operate the whirlpool sys-

tem with the suction/intake cover removed! It is a safety

device and must always be in place on the suction fitting

to minimize the potential hazard of hair and/or body en-

trapment.

Lighting (Chromotherapy lighting)

Your unit has Chromotherapy (LED) lighting. If the lights

fail to function contact your Jacuzzi Whirlpool Bath dealer.

There are no customer serviceable components on the Chro-

motherapy lighting.

Replacement fixtures are available from your Jacuzzi

Whirlpool Bath dealer.

Lighting (optional Illumatherapy

If your unit has Illumatherapy (fiberoptic) lighting and the

lights fail to function contact your Jacuzzi Whirlpool Bath

dealer. There are no customer serviceable components on

the Illumatherapy lighting.

Replacement fixtures are available from your Jacuzzi

Whirlpool Bath dealer.

Jacuzzi Whirlpool Bath K339000X 3/06