Using Your Blender - Oster 6800-6839 User Manual

Clean blender according to the instructions in the
"Cleaning and Storing Your Blender" section.
Jar Assembly:
– Turn jar upside down so the small opening
is at the top. (Figure 1)
– Place sealing ring over jar opening. (Figure 2)
– Place blade into jar. (Figure 3)
– Snap threaded bottom disc and collar together.
Place collar over blade and jar. (Note: If there
are slots on top of collar, line them up with
notches on jar.) Place the collar on jar and turn
the threaded bottom disc clockwise to tighten.
(Figure 4)
– Place jar assembly onto base. (Figure 5)
– Place ingredients into jar.
– Place lid with feeder cap on jar.
– Plug the power cord into a 120 Volt
AC electrical outlet.
P B
USH UTTON
Slide switch to HIGH or LOW (If your model does
not have a slide switch, push HIGH or LOW button.)
Push desired speed and blend ingredients to
desired consistency.
Push OFF to stop the blender and turn blender off.
To use PULSE, select HIGH or LOW. Push PULSE and
hold down for desired length of time.Release PULSE
and allow blade to stop. Repeat cycle as desired.
D M
IAL ODELS
Turn dial to desired food/drink selection.
Press ON and blend ingredients to desired
consistency.
Press OFF to stop the motor and turn blender off.
Note: Food/drink selection can be changed during
blending by turning the dial to the desired selection.
Note: This blender is programmed to turn the
power off automatically if not used for a period
of several minutes.
To use PULSE, turn dial to desired food/drink
selection. Press PULSE and hold down for desired
length of time. Release and allow blade to stop.
Repeat cycle as desired.
U
SING
M
ODELS
W T
ITHOUT IMER
Y B
OUR LENDER
English 6
F 1
IGURE
F 2
IGURE
F 3
IGURE