Table of Contents
Advertisement
SEATBACK HEIGHT
You can adjust the seatback to one of
three different heights. The adjustment
range is 7.5 cm in 2.5 cm increments. See
figure 18.
To adjust the seatback height:
1. Remove the bolts to unfasten the seat
canes from each side of the frame.
2. Slide the canes up or down into one of
the three holes for the desired height.
3. Use the bolts to refasten the seat canes
into the frame.
ARMREST HEIGHT (OPTIONAL)
The armrest has seven holes that are
spaced 2.5 cm apart. See figure 19.
To adjust the armrest:
1. Pull back the release pin located on
the armrest.
2. Move the armrest up or down.
3. Release the pin.
4. Make sure the armrest locks into place.
SEAT ANGLE (DUMP)
The position of the caster wheels affects
the angle of the seat (dump). There are four
holes in the caster fork. By changing the
location of the caster wheel on the fork, you
change the seat angle. See figure 20.
NOTE: You can also adjust the seat
angle by raising or lowering the drive
wheel. See "Drive Wheel Position."
To change the seat angle:
1. Remove the hardware that fastens the
caster wheel to the caster fork.
2. Reposition the caster wheel on the
caster fork.
3. Reinstall the hardware that fastens the
caster wheel to the caster fork.
4. Repeat the procedure for the other side.
WARNING! Changing the seat angle may adversely affect stability and cause
the wheelchair to tip over. Failure to heed can result in personal injury and/or
damage to your wheelchair.
Pride Stylus/RevA/Jan04
Figure 18. Seatback Height
Adjustment
RELEASE PIN
Figure 19. Armrest Height
Adjustment
CASTER
WHEEL
Figure 20. Caster Wheel Position
www.pridemobility.com
SEAT
CANES
BOLTS
FRAME
CASTER FORK
17
Advertisement
Table of Contents
