Accessories; Duty Cycle; Assembly; Installation - Craftsman 919.167600 Owner's Manual

This unit is capable of powering the following Accessories. The accessories are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.

Accessories

• In Line Filter
• Tire Air Chuck
• Quick Connector Sets (various
sizes)
• Air Pressure Regulators
• Oil Fog Lubricators
• Air Hose: 1/4", 3/8" or 1/2" I.D. in
various lengths
This air compressor pump is capable
of running continuously. However, to
prolong the life of your air compressor,
it is recommended that a 50%-75%
average duty cycle be maintained; that
Unpacking
1. Remove unit from carton and discard all packaging.
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
• Locate the air compressor in a
clean, dry and well ventilated
area.
• The air compressor should be
located at least 12" (30.5 cm)
away from the wall or other
obstructions that will interfere
with the flow of air.
• Place the air compressor on a flat
level surface resting on the rub-
ber bumpers and wheels
• The air compressor pump and
shroud are designed to allow for
proper cooling. The ventilation
openings on the compressor are
necessary to maintain proper
operating temperature. Do not
place rags or other containers on
or near these openings.
1000002920
ACCESSORIES
Refer to the selection chart located on
the unit to select the tools this unit is
capable of powering.
not recommended for use with
this tool could be hazardous. Use
only accessories rated equal to
or higher than the rating of the air
compressor.

DUTY CYCLE

is, the air compressor pump should
not run more than 30-45 minutes in
any given hour.

ASSEMBLY

INSTALLATION

GROUNDING INSTRUCTIONS
of a short circuit, grounding reduces
the risk of shock by providing an
escape wire for the electric current.
This air compressor must be
properly grounded.
The portable air compressor is
equipped with a cord having a ground-
ing wire with an appropriate grounding
plug (see following illustrations).
1.
IMPORTANT: The outlet being used
must be installed and grounded in
accordance with all local codes and
ordinances.
10- ENG
The use of any
other accessory
Risk of Electrical
Shock. In the event
The cord set and plug with this
unit contains a grounding pin.
This plug MUST be used with a
grounded outlet.