GMC Sierra Denali Classic 2007 Owner's Manual page 55

CAUTION:
{
Children can be seriously injured or
strangled if a shoulder belt is wrapped
around their neck and the safety belt
continues to tighten. Secure any unused
safety belts behind the child restraint so
children cannot reach them. Pull the
shoulder belt all the way out of the
retractor to set the lock, if your vehicle
has one, after the child restraint has been
installed. Be sure to follow the
instructions of the child restraint
manufacturer.
Notice: Contact between the child restraint or
the LATCH attachment parts and the vehicle's
safety belt assembly may cause damage to
these parts. Make sure when securing unused
safety belts behind the child restraint that
there is no contact between the child restraint
or the LATCH attachment parts and the
vehicle's safety belt assembly.
Folding an empty rear seat with the safety
belts secured may cause damage to the safety
belt or the seat. When removing the child
restraint, always remember to return the safety
belts to their normal, stowed position before
folding the rear seat.
1. If the child restraint manufacturer recommends
that the top tether be attached, attach the top
tether to the top tether anchor. Refer to the
child restraint instructions and the following
steps:
1.1. If the position you are using has an
adjustable head restraint, raise the
head restraint.
1.2. Raise the seat cushion by pulling up on
the strap loop at the rear of the seat
cushion. See Rear Seat Operation
on page 14 for additional information.
Then fold the seat cushion forward.
1.3. Fold the seatback forward.
1.4. Place the child restraint in the vehicle,
near the seating position that you are
using.
55