Opening The Case / Dismantling; Disposal - Violectric PRE V630 User Manual

DISMANTLING / JUMPER SETTINGs
In order to change any DIP switch or jumper settings inside the PRE
V630, its case must be opened. For this purpose, a TORX screwdriver
T10 or 3mm allen key is required, and you should - by all means -
PULL THE MAINS PLUG !!!
after which any setting procedures can be effected without risk.
Disassembly
1. remove the two upper screws on the front panel
2. loosen the two lower screws on the front panel by 2 to 3 turns
3. remove the two upper screws on the rear panel
4. lift off the lid to gain access to the switches/jumpers
5. reassemble the unit in reverse order.

DISPOSAL

By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of this product. The
recycling of materials will help to conserve natural resources.
For more detailed information about recycling of this product, please contact
your local Civic Office, your household waste disposal service or the shop where
you purchased the product.
Disposal of Old Electrical & Electronic Equipment
(Applicable in the European Union and other European
countries with separate collection systems)
This symbol on the product or on its packaging indicates
that this product shall not be treated as household waste.
Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic
equipment.
16