Problem Solving Guide - Miele K 5122 Ui Operating And Installation Instructions

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if . . .
. . . the appliance does not get cool.
^ Make sure that the temperature
selector is not set at "0".
^ Check that the plug is correctly
inserted in the socket and switched
on.
^ Check that the fuse is not defective
and that the mains fuse has not
blown. If it has, contact the Miele Ser-
vice Department.
. . . the temperature in the refrigerator
is too low.
^ Turn the temperature selector to a
setting closer to "0".
. . . the appliance is switching in too
frequently and for too long.
^ Check whether the ventilation gaps at
the bottom of the appliance have
been covered over or become too
dusty.
^ The door has been opened too
frequently, or a large amount of fresh
food has been put in at once.

Problem solving guide

^ Check that the door has been closed
properly.
. . . the interior light is not working.
^ Has the contact switch become
stuck?
If this is not the case, then the lamp is
defective.
^ Disconnect the appliance from the
mains. Switch off at the wall and
withdraw the plug from the socket, or
disconnect the mains fuse or remove
the screw-out fuse in countries where
this is applicable.
^ Grasp the light cover and pull it
forwards to remove it.
^ Unscrew the lamp by turning it
clockwise, and replace it with a new
one.
Lamp specification:
220 - 240 V, E 14 fitting.
See old lamp for wattage.
^ Replace the cover.
. . . the floor is wet.
The drain hole is blocked.
^ Clean the condensate channel and
drain hole.
21