Download Print this page

Miele K 8867 S-1 Operating And Installation Instructions

Refrigerator with stayfresh zone

Advertisement

Quick Links

Operating and installation instructions
Refrigerator
with StayFresh zone
K 8867 S-1
G
To avoid the risk of accidents or
damage to the appliance, it is
to read these instructions
before it is installed or used for the
first time.
M.-Nr. 06 499 270

Advertisement

loading

Summary of Contents for Miele K 8867 S-1

  • Page 1 Operating and installation instructions Refrigerator with StayFresh zone K 8867 S-1 To avoid the risk of accidents or damage to the appliance, it is to read these instructions before it is installed or used for the first time. M.-Nr. 06 499 270...
  • Page 2: Different Types Of Unpacked Meats And Vegetables Must Be Kept Separate

    ..........4 .
  • Page 3 ..........24 Cleaning the outer casing, the interior and accessories .
  • Page 4: Safety Lock

    a Safety lock indicator light d Controls for setting the temperature left hand button: warmer b On/Off button right hand button: colder c Temperature display e Super cool button and indicator light f Alarm off button...
  • Page 5 g Butter and cheese compartment h Egg tray i Interior lighting j Bottle divider* k Shelf l Fruit and vegetable containers m Bottle shelf n StayFresh zone, dry compartment o Condensate channel and drain hole p Control for setting the moisture level in the humidity controlled compartments q StayFresh zone, humidity controlled...
  • Page 6 Please ensure that the appliance presents no danger to children while The transport and protective packing being stored for disposal. has been selected from materials which are environmentally friendly for It should be unplugged or disposal, and can normally be disconnected from the mains electricity recycled.
  • Page 7 This appliance complies with all This appliance contains the coolant relevant legal safety requirements. Isobutane (R600a), a natural gas Improper use can, however, present which is environmentally friendly. a risk of both personal injury and Although it is flammable, it does not material damage.
  • Page 8 Before connecting the appliance to persons could be dangerous and the the mains supply make sure that manufacturer will not be held liable. the rating on the data plate Ensure current is not supplied to the corresponds to the voltage and appliance until after maintenance or connected load of the household repair work has been carried out.
  • Page 9 Observe the "use by" dates given The appliance is designed for use on food to avoid the risk of food within certain climate ranges poisoning. (ambient temperatures), and should not Storage times will depend on several be used outside this range. The climate factors, including the freshness and range for your appliance is stated on quality of the food as well as the...
  • Page 10 Before disposing of an old appliance, first make the door latch or lock unusable. This way you will prevent children from accidentally locking themselves in and endangering their lives. Disconnect the appliance. Cut off the cable and render any plug unusable.
  • Page 11 In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not situated near to a heat source Situated near to a heat source (radiator, oven). (radiator, oven). Where the ambient room Where there is a high ambient room temperature is ideal at approx.
  • Page 12 ^ Clean the inside of the appliance and The safety lock can be activated to the accessories with warm water and prevent the appliance being switched a little washing up liquid, and then off inadvertently. dry with a soft cloth. Important: To ensure the correct functioning of the appliance, let it stand for...
  • Page 13 If the appliance is not going to be used for a longer period of time, e.g. whilst on holiday, ^ switch the appliance off, ^ switch off at the wall socket and withdraw the plug, ^ clean the appliance out and ^ leave the door ajar to air the appliance.
  • Page 14 It is very important to set the correct temperature for storing food in the appliance. Micro-organisms will cause Use the two buttons underneath the food which is not stored at the correct temperature display to set the temperature to deteriorate rapidly. temperature for the refrigerator section.
  • Page 15 ^ Press one of the temperature selector If you have adjusted the temperature, buttons repeatedly until a appears in the display. Press the Super cool button again. , before checking the temperature lights up in the display. display as it will take this long for the ^ You can now adjust the temperature display to show the accurate temperature of the appliance.
  • Page 16 The Super cool indicator light flashes and a flashes in the temperature During normal operation, the display. temperature display on the control ^ Press one of the temperature selector panel shows the average temperature in the refrigerator section. buttons repeatedly until an appears in the display.
  • Page 17 Your appliance has been fitted with an alarm to avoid energy being wasted if the door is left open and to prevent stored food becoming too warm. The alarm will sound if the door is left open for more than approx. 60 seconds.
  • Page 18 The Super cool function can be used to The Super cool function switches itself rapidly reduce the temperature in the off automatically after approx. 6 hours. refrigerator section to its lowest setting The indicator light goes out and the (depending on the room temperature). appliance continues running at normal power.
  • Page 19: In The Refrigerator Section And In The Stayfresh Zone

    Do not store explosive materials in Due to the natural circulation of the air the appliance or any products in the appliance, there are different containing propellants (e.g. spray temperature zones in the refrigerator cans). Danger of explosion. section. Cold, heavy air sinks to the lowest section of the appliance.
  • Page 20 The StayFresh zone is divided into two areas: ^ To set a humidity level of approx. – The has a relative 90 %, slide the control for the humidity level of approx. 45 %. humidity controlled compartment over to the right -. –...
  • Page 21 Store food covered or packaged. This will prevent food smells or tastes from affecting other foods, and prevent food To avoid any microbiological from drying out and also any cross-contamination, these foods may cross-contamination of bacteria. The only be stored together if they are growth of bacteria, such as salmonella, wrapped.
  • Page 22 ^ Push the door shelf upwards, then The shelves can be adjusted according to the height of the food. remove it by pulling it forwards. ^ Pull the shelf forward as far as it will ^ Replace the door shelf at the go;...
  • Page 23 Condensate and frost can build up on the back wall of the refrigerator section and the StayFresh zone whilst in use. These are automatically removed and defrosted by the appliance. The condensate is drained away via a channel and drain hole into an evaporation system at the back of the appliance.
  • Page 24 Aluminium is affected by the way that A microfibre "E-Cloth" is available from light falls on it, by the surrounding the Miele UK Spare Parts Department, environment and by the angle you which is suitable for cleaning surfaces observe it from.
  • Page 25 In addition to the cleaning agents mentioned previously, you should also avoid The metal grille at the back of the – stainless steel cleaners, appliance (heat exchanger) should be dusted at least once a year. A build-up – cleaning agents containing of dust will increase the energy descaling agents, consumption of the appliance.
  • Page 26: Temperature Display

    A loss and that the mains fuse has not of coldness for a short period will not blown. If it has, contact the Miele Ser- affect the food in the appliance. vice Department. There is a fault. Call the Service ^ Select a warmer temperature.
  • Page 27 If you still cannot remedy the fault withdraw the plug from the socket, or having followed these suggestions, disconnect the mains fuse or remove please contact the Miele Service the screw-out fuse in countries where Department. this is applicable. To prevent unnecessary loss of...
  • Page 28 Humming noise made by the motor (compressor). This noise can get louder for brief periods when the motor is switching on. A gurgling noise can be heard when coolant is circulating through the pipes. Clicking sounds are made when the thermostat switches the motor on and off.
  • Page 29 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer – the Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
  • Page 30 All electrical work should be carried out The fuse cover must be re-fitted when by a suitably qualified and competent changing the fuse, and if the fuse cover person in accordance with local and is lost, the plug must not be used until a national safety regulations.
  • Page 31 Do not place any appliance which gives off heat, such as a toaster or microwave oven, on top of this +10 °C to +32 °C +16 °C to +32 °C appliance, as this would increase +18 °C to +38 °C the appliance's energy +18 °C to +43 °C consumption.
  • Page 32 ^ To align the appliance adjust the feet using the spanner supplied.
  • Page 33: Door Handle

    ^ Remove the cover caps from the The appliance is supplied right-hand hinged. If left-hand door hinging is opposite side, and fit them into the required, follow the instructions below. empty holes. ^ Open the appliance door. First the side section of the handle must be removed: ^ Pull door handle a towards you.
  • Page 34 ^ Hang the door in hinge pin c (remember to use washer a), then close the door. In the following illustration the door is not shown in the closed position to make it easier to see what happens next. ^ Open the door, tilt it downwards and take it off.
  • Page 35: Door Seal

    ^ Refit plinth fascia d, pushing it firmly ^ Slide the side section of the handle d into the guides on the mounting into position. plate until it clicks into place. ^ With the door open, position cover e in the front of the plinth fascia, and It is important to check that the side push it firmly into position.
  • Page 36 Make sure that the compartment lid ^ Pull the compartment right out by covers the compartment correctly. taking hold of it at the back and lifting it up to remove it. ^ Pull the compartment lid forwards a. ^ Push the compartment lid in towards the side that the appliance is going to be opened from once the hinges have been changed over b, and fit it...
  • Page 40 Alteration rights reserved / 5104 M.-Nr. 06 499 270 / 00 en - GB K 8867 S-1...