Programming Using The Qmac Pendant Programmer - Sunrise Medical Quickie Smart Seat User Instruction Manual

V I I . S e t - u p P r o c e d u r e
C. PROGRAMMING USING THE QMAC PENDANT PROGRAMMER
1. Insert connector into programmer port on front of QMAC– see section XIII.
2. Press "Enter" to access menus:
i. Move
ii. Configure
iii. Shear Program
MOVE PROFILE
Activates motion profiles independent of user input activation (i.e. joystick or specialty input).
NOTE– The move profile is used primarily to test programmed configuration.
Navigating the Move Menu with the QMAC Pendant Programmer:
1. Up " " and Down " " arrow keys operate individual function displayed
2. Left " " and Right " " arrow keys move between motion profiles
3. Enter key moves one step down in menu
4. Escape key moves one step up menu
There are five options under "Move".
1. Recline – Moves back only. May also move legrests – if so equipped and configured to
do so.
2. Tilt – Moves Seat and Back simultaneously – if so equipped.
3. Left ELR – Moves left legrest – if so equipped.
4. Right ELR – Moves right legrest – if so equipped.
5. Dual ELR – Moves both legrests simultaneously.
CONFIGURE PROFILE
Allows seating system to be configured based on the needs, disability and range of motion
of end user.
Navigating the Configure Menu with the QMAC Pendant Programmer
1. Up " " and Down " " arrow keys change numerical values and select yes/no.
2. Left " " and Right " " arrow keys move between function options
3. Enter key moves one step down in menu
4. Escape key saves the current parameter and moves one step up menu
The following options are under "Configure":
Recline– Allows Recline profile to be configured. The Recline profile can simply enable
the recline function, or it can enable recline while activating the Dual Elevating
Legrests. Enhanced Recline, when enabled, elevates the seat to a preset angle before
coming up out of a reclined position.
Tilt– Allows Tilt function to be configured.
Left Legrest– Allows Left Elevating Legrest to be configured.
Right Legrest– Allows Right Elevating Legrest to be configured.
System– Allows Configuration of various aspects of system. These include:
a. Switched Input Latched – allows "latching" of 5-switch control device for one
touch operation. See section VIII: B on 5-switch control.
When using latched mode to control seeating system, user must maintain access
to input device to insure ability to limit movement as desired.
b. Configure 5 Switch Functions– Indicates assignment of the five switches to the cor-
responding function and allows option of reassignment of all switches as appropriate.
c. Re-Home Seat – resets actuators to initial "home" position. As display indicates,
press and hold the enter button. Continue to hold enter for three to four seconds
after all actuators have ceased moving.
User should never be seated in seating system when Re-Home is being used.
d. System Config. Reset Chair – resets parameters to factory presets
NOTE– Use of this feature will cause loss of all individually programmed parameters.
Compare to a Control-Alt-Delete type reset. This function automatically leads into
the Re-Home Seat function, which should always follow the System Config. Reset
Chair function.
YES
NO
ESCAPE ENTER
CONFIGURE
YES
NO
ESCAPE ENTER
E n g l i s h
MOVE MOVE
YES
NO
YES YES
NO NO
ESCAPE ENTER
ESCAPE ESCAPE ENTER ENTER
CONFIGURE CONFIGURE
SHEAR
YES YES
NO NO
YES
NO
ESCAPE ESCAPE ENTER ENTER
ESCAPE ENTER
11
930473 Rev. B