Setting Of Motion Detection - Panasonic WV-CP310 Operating Instructions Manual

Important:
• The following circumstances may result in detection failure or false detection. Use the camera after adjusting the detection area
and sensitivity.
• Not enough difference in brightness between the background and the moving photographic subject, or significant changes in
brightness
• Dirt or water drops on the lens
• Insufficient brightness, for example, when shooting at night
• The subject is moving straight at the camera
• The subject is moving too fast or too slow
• The subject is too small or too large
• There are too many moving objects
• Light reflected through a window or from a road surface
• The camera is shaking
• Entry of outside light, such as sunlight or the headlights of a car
• Flickering fluorescent light
• Subject change detection may fail in the following cases.
• The lens is partially covered or covered with a transparent item
• The photographic subjects before and after changing the camera direction are similar
• False detection may occur for approx. 1 minute after turning on the power, after completing settings in the SETUP menu, or after
changing the camera view angle.
• Motion detection is the detection function within the screen range for electronic zoom of 1x.
"CAMERA SETUP" screen
**CAMERA SETUP**
SCENE1
ALC/ELC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
D&N(IR) AUTO1
VMD MOTION DET
RET TOP END

Setting of motion detection

Move the cursor to "VMD", press the [LEfT ] or [RIghT ] button to select "MOTION DET".
Step 1
Move the cursor to "MOTION DET" and press the [SET] button.
→ The "MOTION DET" screen appears.
Step 2
Move the cursor to "MASK SET" and press the [SET] button.
→ The mask setting screen appears.
"MOTION DET" screen
** MOTION DET **(1)
.... I .. 20
LEVEL
- +
DWELL TIME
2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END
In the masked area, no alarm will be issued even if a moving object is detected. The masked area is set in the same way as the
masked area setting in "Light quantity control method selection". (
"MOTION DET" screen
** MOTION DET **(1)
.... I .. 20
LEVEL
- +
DWELL TIME 2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END
Mask setting screen
 page 11)
17