Lan Port - Buffalo WAPS-APG600H User Manual

Chapter 3 Configuration

LAN Port

This makes the settings for a wired LAN port.
---> LAN Settings > LAN Port
Parameter
Wired LAN Port
Enable
Media Type
MDI
Flow Control
802.3az
If the IP address, IP address setting method, management VLAN ID, or VLAN settings of the wired
LAN port is changed, you may be unable to proceed with the setting operation.
Meaning
Displays the port number of the wired LAN port.
Sets the wired LAN port status to Enabled or Disabled.
Sets the communication speed of the wired Ethernet connection.
Normally, use at the "Auto" setting. If the connected device cannot
be automatically recognized, try using another setting.
Sets the communication status (straight-through or crossover
connection) of the AirStation with the connected device.
Normally, use at the "Auto" setting. If the connected device cannot
be automatically recognized, try using another setting.
Sets flow control.
If flow control is enabled, overflows of the receive-side buffer
are detected, and a specific frame is sent to enable send-side
restriction.
Sets IEEE802.3az EEE.
When enabled, the power supplied to the LAN port when data is
not flowing can be limited.
Note: The device connected to the AirStation must also support
IEEE802.3az EEE.
- 26 -