Table of Contents
Advertisement
Fast Rewind
Press the FR (Fast Rewind) button 7.
•
Once the tape has been completely
rewound, the set begins playing it
again.
Stopping the Fast Rewind Operation
Press the FF button 9.
•
Autoreverse
If, while a tape is playing, you wish to switch
to the other side of that tape:
press the FF 9 and FR 7 buttons
•
simultaneously.
At the end of the tape the set will automati-
cally switch to the other side of the tape.
Note:
When using stiff-going cassettes, the set
may switch over to the other side although
this is not desired. When this happens check
the tape wound up so far; in these cases, fast
forwarding or rewinding it often helps.
22
Care Notes
We recommend C-60 and C-90 type tapes
for use in any automobile tape player; to
protect your tapes, store them in a cool place
away from dirt, dust, or excessive tempera-
tures above 50° Celsius. In order to ensure
smooth tape operation, cold tapes should be
allowed to warm up a bit before they are
played. If dust collects on the audio head or
the rubber roller, problems related to rough
tape operation or poor sound quality may
occur after approx. 100 hours of operation.
For normal contamination, use a head-
cleaning cassette to remove the dust; for
more intensive contamination, use a cotton-
wool tip soaked with alcohol. Never use hard
tools!
Appendix
Technical Data
Amplifier
Output power:
4 x 4.5 W watts RMS
acc. to DIN 45324/3.1
into 4 Ω
FM
Sensitivity:
0.9 µV at 26 dB
signal-to-noise ratio
Frequency
response:
35 - 15 000 Hz (-3 dB)
Tape Section
Frequency
response:
31.5 - 16 000 Hz (-3 dB)
Modifications reserved!
Hide quick links:
Advertisement
Table of Contents
