Central Pneumatic 66871 Set Up And Operating Instructions Manual page 14

IMPORTANT: Clean the Spray Gun IMMEDIATELY after use.
Improper cleaning will cause the Spray Gun not to work properly.
Materials dry quickly which will render the gun useless.
It is extremely difficult to remove dry paint from small passages within the Gun.
4. After disconnecting, be aware that air
pressure may still remain in the Spray
Gun. Point the Spray Gun into the
spent solvent container and squeeze
the Trigger again to make sure no air
remains.
5. Remove the Air Cap and soak it in
solvent until it is clean. Use an old
toothbrush and toothpicks to remove
any material.
Note: Do not use metal objects to clean
the Air Cap or you may damage the
drilled passages.
6. Inspect the fluid needle and make
sure it is not bent. If it is bent, have it
replaced by a qualified service techni-
cian.
CAUTION: Do not immerse the
Spray Gun Body in solvent.
7. Use the appropriate solvent (depend-
ing on the material sprayed) to wipe
down the Spray Gun body.
8. Lubricate the Spray Gun after clean-
ing. You may use a non-silicon oil or
a light lubricant on all threaded con-
nections prior to storing the unit.
Solution Disposal
After cleaning your Spray Gun, prop-
erly dispose of your cleaning solu-
tions according to the solution manu-
facturer's directions and local hazard-
ous waste standards.
For technical questions, please call 1-800-444-3353.
SKU 66871
Troubleshooting section near end of manual.
Daily - Air Supply Maintenance
Every day, perform maintenance on
the air supply according to the com-
ponent manufacturers' instructions.
Page 14