Table of Contents
Advertisement
10.
While holding the other end of the rear
axle shaft (
14
) with a wrench, remove
the axle nut (
15
11.
Pull the rear axle shaft out and remove
the side collar.
12.
Move the wheel to the right to separate
it from the final drive gear case.
13.
Remove the wheel.
LEFT REAR
(15)
(15) axle nut
).
If You Have a Flat Tire
Installation
Before installing the wheel, check that the
wheel hub and final drive gear splines are
coated with molybdenum disulfide paste
(USA only: Pro Honda Moly 60 Paste, or
equivalent).
1.
Position the wheel between the
swingarm and the final drive gear case.
Be sure the splines on the wheel hub fit
into the final drive gear case.
2.
Install the side collar into the brake
panel.
3.
Insert the rear axle shaft from the right
side, through the right swingarm, brake
panel, wheel hub and final drive gear
case.
Taking Care of the Unexpected
(cont'd)
159
Advertisement
Chapters
Table of Contents
