Kenwood KSC-SW10 Instruction Manual page 6

Connecting the subwoofer to the speaker output of the center unit with
built-in amplifier
Center unit
Examples
The following shows a typical connection for effective car stereo enjoyment. Connect your system by referring to the example.
If there is no power control
terminal in the center unit,
connect the blue/white wire
to the accessory line
(ignition key switch ACC posi-
tion line).
Car fuse box
Ignition key
switch
Car fuse box
(Main fuse)
Battery
Front speaker
Rear speaker
KSC-SW10
Center unit
Fuse 10A
I f buzzing noise is heard from the speakers
when the engine is running, attach a line noise
filter (commercially available) to the power
lead.
Caution:
Connect the black lead wire ground terminal directly with a screw to an unpainted
metal part of the vehicle. Turning the power ON without connecting this terminal is
linked to damage of the stereo system. Be sure to connect it.
Also, painted metal panels etc., are not grounded and will not function correctly. Be
careful.
Autogood products internet store http://130.com.ua
Connect the subwoofer to the front or rear output
cords of the center unit.
Note:
Read the instruction manuals for the connected components such
as the center unit as well as this instruction manual.
White
White/Black
Gray
Gray/Black
Blue/White
Yellow Yellow
Black
Front or rear speaker
Left Right
6 10-pin connector cord
English