Troubleshooting
problem
Belt/Disc Sander
1. Not plugged in.
does not turn on
2. No power at outlet.
3. Safety Key not inserted into Switch.
4. Switch is not turned "ON".
Motor slows
1. V-Belt too tight.
when sanding
2. Applying too much pressure
while sanding
Wood burns
1. Sanding disc or belt may be
while sanding
loaded with dirt or debris.
2. Too much pressure.
Follow all safety precautions whenever diagnosing or servicing
the tool. Disconnect power supply before service.
Item 97181
possible causes
For technical questions, please call 1-800-444-3353.
Likely Solutions
1. Plug in Sander.
2. Check power at outlet and/or circuit breaker.
3. Insert Safety Key into Switch.
4. Turn on the Switch.
1. Have the V-Belt adjusted by a qualified technician.
2. Use less pressure.
1. Clean or replace disc or belt using
instructions in this manual.
2. Use less pressure.
Page 13