Macro Setup - Silvercrest SFB 10.1 A1 Operating Manual

Note:
Should the notice not change to "LEARNING" you have
selected a button for which no button code can be
taught.
6. Point the infrared sensors 2) of both remote controls
towards each other.
7. Now hold down the desired button of the original
remote control until "SUCCESS" or "LEARN ERROR"
appears in the display q of the URC.
8. If in the LCD display q "SUCCESS" appears (process
successful), you can teach further buttons begining with
step 5. If "LEARN ERROR" appears (process unsuccessful)
repeat the process in any case from step 5.
9. To cancel/terminate the learning process, during the
display "LEARN SET", repeatedly the EXIT button y until
the standard display is show in the LCD display q. Dur-
ing the notice "LEARN KEY" and/or "LEARNING" simply
allow 30 seconds to pass without any operation then the
device will end the menu.
Delete all programmed buttons of all devices
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the  or  button t select the menu "LEARN
SETUP" and then press the OK button l. In the LCD
display q "LEARN SET" appears.
3. With the  or  button t select "LEARN CLEAR"
(taught delete) and confirm with the OK button l. In
the LCD display q "CONFIRM CLEAR" (confirm delete)
appears.
4. Confirm with the OK button l. In the LCD display q
"SUCCESS" appears. All programmed buttons are de-
leted. Finally the menu will automatically end.
Note:
When the LCD display shows "CONFIRM CLEAR" you can
stop the deletion with the EXIT button y.
Macro Setup
With the MACRO function up to 16 button commands can
be carried out with the press of a single button, that is to say,
several previously saved control commands can be deleted
with one MACRO button. There are 6 Macro memory slots
available for you.
To programme a Macro
For Macro programming proceed as follows:
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the  or  button t select "MACRO SETUP" and
confirm with the OK button l. In the display "MACRO
SETUP 1" appears.
- 20 -