Selecting The Source To Play; Adjusting The Volume [Volume]; Listening With Headphones (Not Supplied); Turning Off The Sound Temporarily [Muting] - JVC TH-P5 Instructions Manual

Basic operations

Selecting the source to play

On the remote control:
Press one of the source selecting
buttons (DVD 3, USB MEMORY 3,
FM/AM or TV SOUND).
DVD 3: To play back a disc (DVD VIDEO, VCD etc.). (See
page 16.)
USB MEMORY 3: To playback a file in a USB mass storage
class device. (See page 16.)
FM/AM: To tune in an FM or AM (MW) station. (See page
34.)
Each time you press the button, the band alternates between
FM and AM (MW).
TV SOUND: To select the TV (that outputs sound signals)
connected to the AV (SCART) connector. (See page 10.)
On the center unit:
Press SOURCE repeatedly until the
source name you want appears on
the display window.
NOTE
• When a source except DVD or USB MEMORY is selected,
this system does not output video signals.
• It may take time to change the source.
Adjusting the volume
[VOLUME]
CAUTION
• Always set the volume to minimum level before starting any
source. If the volume is set at a high level, the sudden blast of
sound could permanently damage your hearing and/or blow
out the speakers.
On the remote control:
Press AUDIO VOL +/–.
On the center unit:
Press VOLUME +/–.
See page 13 for button locations.
Listening with headphones
(not supplied)
CAUTION
Be sure to turn down the volume;
• Before connecting or putting on headphones as high volume
may damage both the headphones and your hearing.
• Before disconnecting headphones as high volume may be
suddenly output from the speakers.
While connecting a pair of headphones to the PHONES
jack on the center unit, the system automatically cancels the
surround mode (see page 20) currently selected, deactivates
the speakers, and activates the headphone mode.
"H.PHONE" appears on the display window.
Headphone mode
When using the headphones, the following signals are
output regardless of your speaker setting;
• For 2 channel sources, the front left and right channel
signals are output from the headphones.
• Multi-channel signals are down-mixed and output from
the headphones.
Turning off the sound
temporarily [MUTING]
Press MUTING.
To restore the sound
Perform one of the following:
• Press MUTING again.
• Press AUDIO VOL +/– (or VOLUME +/– on the center
unit).
Adjusting the brightness of
the indications [DIMMER]
Press DIMMER with SHIFT pressed.
Each time you repeat the procedure, you can change the
brightness level in 3 steps.
14