Selecting The Source To Play; Adjusting The Volume; Turning Off The Sound Temporarily; Adjusting The Brightness - JVC THM42 Instructions Manual

Basic operations
Selecting the source to
play
On the remote control:
Press one of the source selecting buttons
(DVD, FM/AM, VCR or DBS).
DVD:
To play back a disc (DVD, Video CD etc.). (A pg. 21, 23)
FM/AM: To tune in an FM or AM station. (A pg. 25)
Each time you press the button, the band alternates
between FM and AM.
VCR:
To select the source from a component connected to the
VCR IN jacks and AUDIO IN (VCR) jacks. (A pg. 12)
DBS: To select the source from a component connected to the
DIGITAL IN (DBS) jack. (A pg. 12)
On the center unit:
Press SOURCE repeatedly until the source
name you want appears on the display
window.
Each time you press the button, the source changes as follows;
] ] ] ]
DVD AM FM VCR
beginning)
The selected source name appears on the display window.
Example: When "VCR" is selected.
NOTE
• When a source except DVD is selected, this system does not output
video signals.

Adjusting the volume

CAUTION
• Always set the volume to minimum level before starting any source.
If the volume is set at its high level, the sudden blast of sound could
permanently damage your hearing and/or blow out the speakers.
You can adjust the volume level within the range from "0"
(minimum) to "70" (maximum).
On the remote control:
Press AUDIO VOL + or –.
• Press + to increase volume.
• Press – to decrease volume.
On the center unit:
Turn VOLUME.
• Turn VOLUME clockwise to increase volume.
• Turn VOLUME counterclockwise to decrease volume.
The volume level appears on the display window.
] ]
DBS (back to the
Turning off the sound
temporarily
On the remote control:
Press MUTING.
"MUTING" appears on the display window and the sound turns off.
To restore the sound
Press MUTING again.
• Pressing AUDIO VOL +/– (or turning VOLUME on the center
unit) also restores the sound.

Adjusting the brightness

You can dim the indications on the display window, the
illumination lamp level on the center unit.
On the remote control:
Press DIMMER.
Each time you press the button, the brightness level changes as
follows;
] ] ]
OFF DIMMER1 DIMMER2
beginning)
• OFF: Returns to the normal level.
• DIMMER1: Dims the display window, the illumination lamp.
• DIMMER2: Dims the display window more than DIMMER1 and
turns off the illumination lamp.
]
(back to the
18