Table of Contents
Advertisement
4
Recording, Archiving & Streaming
Recording and Streaming
A streaming/recording session can be started and
stopped from the Start/Stop section of the main toolbar
and from the profile listing. The "default" profile will
be used unless another profile is selected. To select an
alternate profile, use the Change button to bring up a
profile listing.
The RED LED will illuminate when the DMR is recording/
streaming and the Web Portal will display a "Recording"
message at the top of the page. The record/stream
parameters will be as specified in the profile that was
chosen.
To stop the recording and create an archived file, press
the Stop button to begin the "indexing" process. The
RED LED on the front of the unit will blink fast during
the indexing procedure, indicating that the unit is
busy and cannot record or stream until the process is
complete. Depending on the length of the archived
material, this could take a few seconds up to several
minutes to complete.
Disabling / enabling multicast
By default the DMR will multicast anytime a profile
is intiated with streaming enabled. Multicast can be
disabled so only unicast streams will be supplied.
To disable multicast, access the CLI and enter the
"multicast off" command.
Changing Profiles
On the Start/Stop page, you can click on the Change
icon and you will get a list pop-up with all available
profiles. Select on the profile of your choice and the
Start/Stop page will automatically be updated.
Content Detail
15
DMR |
Advertisement
Table of Contents
