Connecting Your System - Pioneer S-FCRW4500 Operating Manual

Home theater loudspeaker system
Table of Contents

Advertisement

Available languages

Available languages

After connecting the speaker wires to the surround speakers, use
the groove provided to secure the speaker wire as shown at left.
Leave 10cm of slack from the speaker terminals so the upper
(surround) speaker can turn freely.
When you're finished, thread the surround speaker cords through
the outlet on the base of the speaker stand as above.
To keep the stand steady when upright, tuck the
speaker cords into the grooves on the bottom as
shown below.
3. Turn the surround speakers 50° towards the closest wall.
The speaker will stop turning at about a 50º angle. This is only
necessary with the Front Surround modes (leave them facing
forward with 5ch STEREO). See the operating instructions for
more on the Front Surround modes.
5ch STEREO
Caution
To prevent accidents when in use, make sure the surround speaker is
secure by turning it so the
arrow at the base of the speaker is not in
the UNLOCK AREA.
With the 3-spot setup, it is recommended that you fix the surround
speakers in place with the adhesive strips provided when in use.
Front Surround
5ch STEREO

CONNECTING YOUR SYSTEM

IMPORTANT:
Make sure all equipment is turned off before making any
connections.
FRONT / CENTER / SURROUND / SUBWOOFER
SPEAKERS
Correct wiring of your loudspeakers is essential for achieving
the best sound quality. Be careful to ensure proper polarity of
connection.
Connect the supplied speaker wires to the receiver speaker
output terminals. Using the color directions below, connect
the non striped wire to the black (–) terminal and the gray
striped wire to the red (+) terminal for each channel. Connect
the other end of each wire to the input terminals at the rear of
each speaker. Connect the non striped wire to the black (–)
terminal and the gray striped wire to the red (+) terminal.
White colored marker
Red colored marker
Green colored marker
Blue colored marker
Gray colored marker
Purple colored marker
Depress the input terminal lever, and insert the tip of the wire
into the hole and then release the lever so that it springs back
into position. Take care that no stray strands of wire short
across between the terminals.
red (+)
black (–)
Non stripe
wire
www.pioneerelectronics.com
Front left speaker
Front right speaker
Front Center speaker
Surround left speaker
Surround right speaker
Subwoofer speaker
Gray stripe
Colored marker
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S-fcw4550

Table of Contents